Schumacher Electric IP-95C Owner's Manual download pdf

Schumacher Electric Corporation

Model IP-1850FL

OWNER’S MANUAL

INSTANT POWER™ Jump Starter & DC Power Source

THIS PRODUCT HAS A SEALED LEAD-ACID BATTERY INSIDE THAT SHOULD BE KEPT AT FULL CHARGE FOR LONGER LIFE.

RECHARGE WHEN FIRST RECEIVED (EVEN IF GREEN ‘FULL POWER’ LED GLOWS), AFTER EACH USE AND EVERY 3 MONTHS.

IMPORTANT SAFETY INSTRUCTIONS

Save these instructions

important safety instructions

Someone should be within range of your voice or close enough to

come to your aid when you are working near a lead-acid battery.

Have plenty of fresh water and soap nearby in case battery acid

contacts skin, clothing, or eyes. If acid enters the eye area,

rinse with cold water for at least 10 minutes and get medical help

immediately.

Do not smoke, or use matches or cigarette lighter, or allow any

spark or ame near the battery or engine.

Never operate the power source unit if it has damaged lead wire or

clamps. Have the lead wire replaced by a qualied technician.

Wear complete eye and clothing protection when working with

lead-acid batteries.

Do not permit the internal battery in the IP-1850FL to freeze. Never

attempt to recharge a frozen battery.

handling warning

WARNING: Handling the cord on this product or cords associated

with this product, may expose you to lead, a chemical known to

the State of California to cause cancer and birth defects or other

reproductive harm. Wash hands after handling.

operating instructions

Warning: Failure to follow instructions may cause

damage or an explosion. Read entire instruction

manual before use.

1. Turn ignition OFF before making cable connections.

2. Use in a well-ventilated area.

3. Keep clear of fan blades, belts, pulleys and other parts that

may cause injury.

4. Make sure the power ON/OFF switch is in the OFF position

until clamps are connected to the vehicle battery.

5. In the ON position, NEVER allow clamps to touch together or

to contact the same piece of metal to prevent sparking.

6. Clamp the red clamp (+) to the positive terminal of the battery.

(For a negative grounded system.)*

7. Clamp the black clamp (-) to an unpainted and unmoving part

of the chassis or engine block.

8. If you have connected the clamps of the IP-1850FL backwards,

an audio alarm will sound. DO NOT turn your IP-1850FL on.

This could cause serious damage. Reverse the connections,

and the audio alarm will stop.

9. If no audio alarm is sounded, turn ON the IP-1850FL, and

then crank the engine. If the engine does not start within

5 – 8 seconds, wait at least 1 minute before attempting to start

vehicle again. (This permits the battery to cool down.)

10. After the engine starts, make sure to turn OFF the power

switch. Then disconnect the black clamp (-) and then the red

clamp (+) in that order. Store the clamps on the ears located

on the sides of the case.

11. Recharge the IP-1850FL as soon as possible after use.

*NOTE: In the rare case of jump-starting a vehicle that has

a positive-grounded vehicle electrical system, connect the

NEGATIVE black clamp (-) to the negative terminal (-) of the

vehicle battery. Then connect the POSITIVE red clamp (+)

to an unpainted and unmoving part of the vehicle chassis or

engine block. If you are unsure of the nature of the vehicle’s

electrical grounding system, check the owner’s manual of the

vehicle. To disconnect clamps, reverse order.

led indicators

To check the internal battery’s charge status, press the red button

on the front of the IP-1850FL.

The LED lights will indicate the charge level as follows:

1. A red LED indicates a 50% or less charge and you should

immediately recharge.

2. A yellow LED indicates a 50 to 75% charge. The IP-1850FL

may be used but should be recharged as soon as possible.

3. A green LED indicates the internal battery is charged.

charging of internal battery with built-in charger.

After removing the IP-1850FL from the carton, charge it for a

minimum of 8 hours before using even if the green Full Power

LED glows.

NOTE: The ON/OFF switch does not have to be in the ON position

to recharge the internal battery.

1. To charge, plug extension cord into charger plug on the back

of the IP-1850FL. (Extension cord not included; must be

purchased separately.)

2. Plug the extension cord into 110V AC electrical wall outlet.

3. The red LED will glow indicating charging.

4. The green LED will glow when the battery has reached full

charge. This could take up to 72 hours on some charges due to

age and condition of the battery. The charger will automatically

drop into a oat mode and maintain the battery at full charge

without damaging the battery. The IP-1850FL can be left

plugged into the 110V wall outlet indenitely to maintain full

power.

5. Recharge the IP-1850FL after use and every 3 months to full

charge status to extend the battery’s life.

multi-purpose power supply

The IP-1850FL is a power source for all 12 volt power accessories

with 12V accessory plug. Make sure the device to be powered

is OFF before inserting 12 volt accessory plug into 12 volt DC

accessory outlet located on the front of the IP-1850FL. Use the 12

volt accessory outlet for power outages, shing and camping trips,

cell phones, camcorders, computers, etc. Estimate usage time is

listed in chart below.)

00-99-000674/1106

1 2

OWNER’S MANUAL 1

Summary of Contents

Page 1 - OWNER’S MANUAL

Schumacher Electric CorporationModel IP-1850FLOWNER’S MANUAL INSTANT POWER™ Jump Starter & DC Power SourceTHIS PRODUCT HAS A SEALED LEAD-ACID BATT

Page 2

12 Volt dc power source chartAppliance Type Estimated Wattage Estimated Time*Cell Phones 4 Watts 30 HoursFluorescent Lights 4 Watts 30 HoursRadi

Comments to this Manuals

No comments

Schumacher Electric IP-95C Owner's Manual

Browse online or download Owner's Manual for Remote starters Schumacher Electric IP-95C. Schumacher Electric IP-95C Owner`s manual User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Remote starters Schumacher Electric IP-95C