Schumacher Electric MC-1 Owner's Manual download pdf (Page 13)

CONTROL PANEL11.

Voltage Selector Switch

This charger has a voltage selector switch on the front of it. Match the charging

voltage (6 or 12 volts) to the voltage of the battery being charged.

Circuit Breaker

This charger is equipped with an internal self-resetting circuit breaker. The

breaker protects the charger from temporary overloads. In the event of an

overload, the breaker will trip open and after a short cooling off period, will

reset automatically. This process is known as cycling and can be recognized

by an audible clicking sound. If the circuit breaker is cycling, see the

TROUBLESHOOTING section.

OPERATING INSTRUCTIONS12.

Charging

Ensure that all of the charger components are in place and in good 1.

working condition, including the plastic boots on the battery clips.

Connect the battery following the connection instructions described in 2.

Using the Quick-Disconnect Cable Connectors section.

Connect the AC power following the precautions listed in Section 8.3.

USING THE QUICK-CONNECT CABLE CONNECTORS

Connect either of the two output cable assemblies to the charger in seconds.

Makesuretoplacethechargeronadry,non-ammablesurfacelikemetalor

concrete.

NOTE: Never connect the clip and ring terminal connectors together for use in

other applications, such as external battery or other power source charging, or to

extend the output cable length, as reverse polarity and/or overcharge conditions

will occur.

BATTERY CLIPS: Connect the battery clip cable assembly to the charger. Follow

the safety instructions in sections 6 or 7 to connect the output clips to the battery.

RING TERMINALS: The ring connectors permanently attach to the battery

providing easy access to quickly charge your battery. This application is

appropriate for motorcycles, lawn tractors, ATV’s and snowmobiles. To

permanently attach it to a battery, loosen and remove each nut from the bolts at

the battery terminals. Connect the red positive ring connector ring to the positive

(POS, P, +) battery terminal. Connect the black negative ring connector ring to

the negative (NEG, N, -) battery terminal. Replace and tighten the nuts to secure

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 49 50

No comments

Schumacher Electric MC-1 Owner's Manual Page 13