Schumacher Electric SE-1052 Owner's Manual download pdf (Page 2)

Charging

Hours

3-6 Hrs.

6-8 Hrs.

3-5 Hrs.

2 minutes on

5 minutes off

5 seconds on

240 seconds off

PREPARING TO CHARGE

Charger Selection Guide (see section H)

Ampere

Rating

2 amp

6 amp

10 amp

30 amp

Boost

50 amp

Engine Start

Recommended Battery

Uses

Charge motorcycle, snow-

mobile, lawnmower, trickle

charge car, truck, RV, marine.

Charges car, truck, RV, trolling

outboard, tractor farm equip-

ment.

Boost battery for 2 minutes

before Cranking Engine.

Cranking assists helps turn

engine when battery power is

low.

PERSONAL PRECAUTIONS AND SAFETY

1. WARNING: Wear complete eye protection and clothing

protection, when working with lead-acid batteries.

2. Make sure someone is within range of your voice or close

enough to come to your aid when you work with or near a

lead-acid battery.

3. Have plenty of fresh water and soap nearby for use if battery

acid contacts skin, clothing, or eyes. If battery acid contacts

skin or clothing, wash immediately with soap and water.

4. Avoid touching your eyes while working with a battery. Acid

particles (corrosion) may get into your eyes! If acid enters

your eye, immediately flood eye with running cold water for

at least 10 minutes. Get medical attention immediately.

5. Remove all personal metal items such as rings, bracelets,

necklaces, and watches when working with a lead-acid

battery. A lead-acid battery can produce a short-circuit

current high enough to weld a ring (or the like) to metal,

causing a severe burn.

6. Take care not to drop a metal tool or other metal onto the

battery. Metal may cause sparking or short circuit the battery

or another electrical device. Sparking may cause an

explosion.

7. Always operate battery charger in an open well ventilated

area.

8. NEVER smoke or allow a spark or flame in the vicinity of

the battery or engine. Batteries generate explosive gases!

GROUND AND AC POWER CORD CONNECTIONSC.

GROUNDING

SCREW

FIGURE 1 GROUNDING METHODS

DANGER: Never alter the AC cord or plug provided. If it will not fit outlet, have a proper outlet installed by a qualified electrician. Improper connection can result

in a risk of an electrical shock. DANGER: Before using an adapter, as illustrated, be certain that the center screw of the outlet plate is grounded. The green-colored

rigid ear or lug extending from the adapter must be connected to a properly grounded outlet. Make certain it is grounded. If necessary, replace original outlet cover

plate screw with a longer screw that will secure adapter ear or lug to outlet cover plate and make ground connection to grounded outlet.

USE OF ADAPTER PLUG NOT ALLOWED IN CANADA

Charger should be grounded to reduce the risk of electric shock.

Charger is equipped with an electric cord having an equipment grounding

conductor and a grounding plug. The plug must be plugged into an outlet

that is properly installed and grounded in accordance with all local codes

and ordinances. This battery charger is designed for use on a nominal 120

volt circuit and has a grounded plug that looks like the plug illustrated in

FIGURE 1 (A). This plug should be used in a grounded outlet. The plug

pins must fit the receptacle (outlet).

ADAPTER: A temporary adapter, as shown in FIGURE 1 (B) and (C), may

be used to connect the charger plug to a two pole receptacle (outlet), as

shown in FIGURE 1 (B).

NOTE: The temporary adapter should be used only until a properly grounded

outlet can be installed by a qualified electrician.

1. Make sure that the voltage of the battery and the charger match.

Select battery charger switch, if this model has one, accord-

ingly.

2. Clean battery terminals. Take care to keep corrosion from com-

ing in contact with your eyes.

3. If required, add distilled water in each cell until battery acid

reaches levels specified by battery manufacturer. This helps

purge excessive gas from cells. Do not overfill. For a battery

without cell caps, carefully follow manufacturer’s recharging in-

structions.

4. Study all battery manufacturer’s specific precautions, such as

removing or not removing cell caps while charging, and recom-

mended rates of charge.

5. Be sure area around battery is well ventilated while battery is

being charged. Gas can be forcefully blown away by using a

piece of cardboard or other non-metallic material as a fan.

6. If necessary to remove battery from vehicle to charge, always

remove grounded terminal from battery first. Make sure all ac-

cessories in the vehicle are off, so as not to cause an arc.

7. A marine (boat) battery must be removed and charged on shore.

To charge it on board requires equipment specially designed

for marine use.

1 2 3 4 5 6 7 8

Comments to this Manuals

Jeffrey 11 Jun 2024 | 17:10:11

What does F01 mean?

Schumacher Electric SE-1052 Owner's Manual Page 2

Comments to this Manuals

Related products and manuals for Battery chargers Schumacher Electric SE-1052