Schumacher Electric XC10 Owner's Manual

Fully AutomaticMicroprocessor ControlledBattery Charger withEngine StarterCAUTION:Read all Safety Rules and Operating Instructions, and follow them w

10CONTROL PANEL GUIDE SC-7500A CONTROL PANEL GUIDEMODE OF OPERATIONChargedChargingCheckBattery%VoltageAlternator%2A12AŻŹ30A75AStart12VRegular12VDeep-C

11USING THE BUILT-IN BATTERY TESTEROVERVIEWThis battery charger has a built-in battery tester that displays either an accurate battery voltage or an e

12This battery charger has a built-in alter-nator tester that displays either an accu-rate alternator voltage or an estimate of the alternator’s relat

13BATTERY PERCENT AND CHARGE TIMEThis charger adjusts the charging time in order to charge the battery completely, efciently and safely. The

14CHARGING TIPSRead this entire manual before using your charger. The tips below serve only as a guide for specic situations.If your vehicle won’t st

15TROUBLESHOOTINGPerformance problems often can be corrected by the user. Please read through this chart for a possible solution to common problems.PR

16WARRANTYSCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CENTER DRIVE, MOUNT PROSPECT, ILLINOIS 60056-2179MAKES THIS LIMITED WARRANTY TO THE ORIGINAL P

2PLEASE SAVE THIS OWNER’S MANUAL AND READ BEFORE EACH USE.Model SC-7500A Microprocessor Controlled, Fully Automatic Operation Battery Charger with Eng

3IMPORTANT SAFETY INSTRUCTIONS• WARNING: Handling the cord on this product or cords associated with ac-cessories sold with this product, may expose y

4Never place charger directly above battery being charged. The gases from the battery will corrode and damage the charger.Never touch the battery clam

5BEFORE USING YOUR BATTERY CHARGERPREPARING YOUR BATTERY TO BE CHARGEDIt is important that you read and follow these guidelines while you are preparin

6OPERATING INSTRUCTIONSNOTE: A marine (boat) boat battery must be removed and charged on shore. To charge it on board requires equipment specially d

71. Note the polarity of the battery posts by checking the identication marks on the battery: POSITIVE (POS, P or +) and NEGATIVE (NEG, N or -). The

8up to 5 seconds or until the engine cranking stops. The digital display shows a countdown of the remaining crank time in seconds. It s

9CHARGER CONTROLSDISPLAY MODE SWITCH Use this switch button to set the function of the digital display to one of the following. • BATTERY %: The digi