Schumacher Electric SE-4022 Operations Instructions download pdf (Page 6)

• 6 •

7. FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE

A SPARK NEAR THE BATTERY MAY

CAUSE A BATTERY EXPLOSION. TO

REDUCE THE RISK OF A SPARK NEAR

THE BATTERY:

7.1 Check polarity of battery posts. POSITIVE

(POS, P, +) battery post usually has a larger

diameter than NEGATIVE (NEG, N, –) post.

7.2 Attach at least a 24-inch-long 6-gauge

(AWG) insulated battery cable to

NEGATIVE (NEG, N, –) battery post.

7.3 Connect POSITIVE (RED) charger clip to

POSITIVE (POS, P, +) post of battery.

7.4 Position yourself and free end of cable as

far away from battery as possible – then

connect NEGATIVE (BLACK) charger clip

to free end of cable.

7.5 Do not face battery when making nal

connection.

7.6 When disconnecting charger, always do

so in reverse sequence of connecting

procedure and break rst connection

while as far away from battery as

practical.

7.7 A marine (boat) battery must be removed

and charged on shore. To charge it on

board requires equipment specially

designed for marine use.

8. GROUNDING AND AC POWER CORD CONNECTIONS

This battery charger is for use on a

nominal 120 volt circuit and has a

grounded plug. The charger must be

grounded, to reduce the risk of electric

shock. The plug must be plugged into

an outlet that is properly installed and

grounded in accordance with all local

codes and ordinances. The plug pins

must t the receptacle (outlet). Do not use

with an ungrounded system.

DANGER: Never alter the AC cord or

plug provided – if it does not t the outlet,

have a proper grounded outlet installed

by a qualied electrician. An improper

connection can result in a risk of an

electric shock or electrocution.

NOTE: Pursuant to Canadian

Regulations, use of an adapter plug

is not allowed in Canada. Use of an

adapter plug in the United States is not

recommended and should not be used.

USING AN EXTENSION CORD

The use of an extension cord is not

recommended. If you must use an

extension cord, follow these guidelines:

• Pins on plug of extension cord must be

the same number, size, and shape as

those of plug on charger.

• Ensure that the extension cord is

properly wired and in good electrical

condition.

• Wire size must be large enough for

the AC ampere rating of charger, as

specied:

Length of cord (feet) 25 50 100 150

AWG* size of cord 16 12 10 8

*AWG-American Wire Gauge

9. ASSEMBLY INSTRUCTIONS

9.1 It is important to fully assemble your

charger before use. Remove all cord wraps

and uncoil the cables prior to using the

battery charger. Follow these instructions

for assembly.

PARTS TOOLS NEEDED

(2) 10-32, thread cutting screws

(2) 10-24 x 5/8” thread cutting screws

(2) wheels

(1) axle

(2) axle caps

(2) axle brackets

(1) handle

(1) foot

3/8" wrench (for mounting foot)

5/16" wrench (for mounting wheels)

1/4" wrench (for mounting handle)

hammer

at-head screwdriver (not included)

Phillips-head screwdriver (not included)

1 2 3 4 5 6 7 8 9 10 11 ... 26 27

Comments to this Manuals

No comments